OCULII LLC VISDAR-RADAR Manual Do Utilizador
OCULII LLC
830 A Space Drive • Beavercreek , Ohio 45434
Phone: (937) 912-9261 • Email: info@oculii.com • Web: www.oculii.com
Step 3: Plug in the power source (either a 12V wall supply or a 12V battery) to the single to dual
supply adapter. Two red power LEDs should illuminate as seen in Figure 3.
supply adapter. Two red power LEDs should illuminate as seen in Figure 3.
Figure 3: Device with power LEDs activated.
Step 4: From this point, the device can be switched between standby and operating modes using the
serial terminal. To move from the standby mode to the operating mode an ‘s’ must be sent over the
serial channel and to move from the operating mode to standby mode an ‘x’ over the serial channel.
In operating mode an additional LED will activate as seen in Figure 4.
serial terminal. To move from the standby mode to the operating mode an ‘s’ must be sent over the
serial channel and to move from the operating mode to standby mode an ‘x’ over the serial channel.
In operating mode an additional LED will activate as seen in Figure 4.
Figure 4: Device with power LEDs and operating mode LED activated.
9