Ruckus Wireless VF7XX1 Manual Do Utilizador

62

Ruckus Wireless MediaFlex 7811 Access Point

3. Connect the CAT5 Ethernet cable to the Ethernet port on your computer, and to the Ethernet port on the 7111.

4. On your PC, open a browser window.

5. Upon login, check the Status :: Wireless page to verify that the wireless status is up. If the status is down, 

then you have a connection problem between the 7811 and the 7111. You may need to reset the unit to factory 
defaults and perform auto provisioning with the 7811.

6. If necessary, reset the 7111 to its factory defaults. Press and hold the Reset button on the device for at least 

eight (8) seconds.

7. Repeat the auto provisioning steps by referring to 

.

Using auto provisioning, you can synchronize wireless settings between the 7111 and the 7811.

In order for the adapter to communicate with the AP, the 7111 must have the same wireless settings (such 
as SSID, security mode, and passphrase) as the 7811. With auto provisioning, the adapter can obtain these 
settings without the need to use a PC for configurtation.

The auto provisioning method is very simple. You simply connect the 7111 to the 7811, and all of the 
wireless settings of the 7811 are securely sent to the 7111.

To perform auto provisioning, perform the following steps:

1. The adapter must be in factory default mode. If the adapter is not in factory default mode, use a pin to depress 

the Reset button (for at least 8 seconds) on the back of the adapter to set it to factory defaults.

2. When the adapter is in default mode, the right two LEDs (Wireless Device Association and the Signal 

Quality) should be blinking in unison. This indicates that the adapter is in factory default mode and is waiting 
to be auto provisioned.

3. The 7811 should be powered on.

4. Use an Ethernet cable to connect the 7811 (any port) to the 7111’s Ethernet port.

5. Observe the Wireless Device Association and the Signal Quality LEDs of the 7111. These LEDs should 

continue to blink in unison.

6. The auto provisioning process will take between 5 to 15 seconds. At the end of this process, these two LEDs 

should turn off.

7. Unplug the Ethernet cable from the 7111. The 7111 will reboot automatically. Be sure that the 7111 is 

rebooting by checking the three right most LEDs.

8. If the 7811 and the 7111 are correctly auto provisioned and associated, the right two LEDs of the 7111 should 

show constant green.