GRAUPNER CO. LTD. 19001200 Manual Do Utilizador

11 / 28

S5012_Alpha_110_jh_V1

Plug the USB connector of the included charger to a suitable 5 

V port. 
1.  The LED on the charger will light green.
2.  Plug the battery connector to the charger charging port.
3.  The LED will turn from green (stand by mode) to red (charge 

mode).

When the charge process has finished, the LED lights on green 

again. Then is the battery fully charged.
4.  Unplug first the battery connector from the battery charger 

and then the USB cable from the power supply.

The 

mz-8 HoTT transmitter is normally delivered with three alka-

line batteries.
The transmitter battery voltage is monitored by a status LED 

during operation. 
If the voltage drops below 3,2 V, an acoustic alarm will sound 

and the red status LED starts to blink quickly. Now at the latest, 

stop operation and change the transmitter batteries!

Inserting the transmitter batteries
To insert the transmitter batteries remove the battery case cover 

on the back side of the transmitter. Insert the included batteries 

in the holder paying attention to the correct polarity (see figure)

Removing the transmitter batteries
If the transmitter is not going to be used for a long time, the bat-

teries should be removed from the device to avoid damages to 
the transmitter due to electrolyte leaks.