Shanghai Helang Electronics Co. Ltd. HL24T2 Manual Do Utilizador

 

 

Congratulations on your purchase of the RoboCopter. Your RoboCopter comes complete and ready to fly 

(except 4× AA transmitter batteries) so you can start to fly as soon as you have fully read the instruction 

manual and have charged the in-built flight battery.   

 

Key Features:   

*Advanced 2.4Ghz radio control system with digital trims 

*Proportional throttle and steering control (2 channels) 

*Computer designed figure  

*Durable foam body   

*Built-in Li-Poly battery for longer flight duration   

*Recharging via the in-built transmitter charger 

 

Damage Limits: 

Yuneec International Ltd. (described as Yuneec below) shall not be liable for special, indirect or 

consequential damages, loss of profits or production or commercial loss in any way connected with this 

product, whether such claim is based on contract, warranty, negligence, or strict liability. Further, as Yuneec 

has no control over use, setup, modification or misuse, no liability shall be assumed nor accepted for any 

resulting damage or injury. 

By the act of use or setup, the user accepts all resulting liability and responsibility.           

 

Safety Precautions:   

Warning: Any change or modification to this product without written approval by the party responsible for 

compliance is prohibited. 

Choking hazard: Includes small parts, not for children under age 8.     

Keep everything, especially hair, away from the main rotors and tail rotor when RoboCopter’s power is on. 

Make sure the transmitter and RoboCopter have their power turned ‘OFF’ when not in use. 

Keep your RoboCopter in sight at all times when flying.  

Do not attempt to charge any battery other than the specified built in one with the charger in the transmitter. 

To help to protect your RoboCopter from damage, remember to close the throttle (pull the throttle stick 

down) immediately to stop the rotors if your RoboCopter falls over or hits something. 

 

FCC Statements 

This device complies with part 15 of the FCC rules. Operation is subject the following two conditions: 

1)This device may not cause harmful interference, and 

2)This device must accept any interference received, including interference that may cause undesired 

operation. 

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against