Shanghai Helang Electronics Co. Ltd. HL24T2 Manual Do Utilizador

harmful interference in a residential installation. This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 

interference to radio communications. 

However, there is no guarantee that interference will not occur in a particular installation .If this equipment 

does cause harmful interference to radio or television reception, which can be determined by turning the 

equipment off and on the user is encouraged to try to correct the interference by one or more of the 

following measures: 

*Reorient or relocate the receiving antenna. 

*Increase the separation between the equipment and receiver. 

*Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

*Consult the dealer or an experienced radio/TV technician for help. 

Battery Cautions for  the  RoboCopter  in  built  Li-Poly battery : 

*Only charge the battery with the in built Transmitter charger. Always carefully follow the charging 

instructions as described below. 

* Do not over-discharge or over-charge the battery. 

* Do not short-circuit, drop impact or penetrate/pierce the battery. 

* Do not put the battery in a fire or near heat. 

* Store the battery in cool dry place and out of the reach of children. 

Transmitter Cautions: 

* Always use of the same brand alkaline AA batteries. Do not mix brands or types of batteries. 

* Do not attempt to charge alkaline non-rechargeable batteries. 

* Rechargeable batteries should be charged under adult supervision. 

Notes for Adults: 

* Examine the RoboCopter carefully for any possible damage prior to every flight. Do not attempt to fly 

until all damage has been repaired. 

* Adult supervision is required when a child is charging the battery in the RoboCopter or 

installing/replacing the batteries in the transmitter. 

Special Caution: Do not touch the PCB (receiver) on your RoboCopter with anything, especially metal, to 

avoid any unnecessary damage. This is not a consumer serviceable item.   

Notes for Maintenance:   

*Remove the transmitter batteries if you are not going to use this product for a long time.   

*Clean the transmitter’s surface with a dry soft cloth if it is dirty. DO NOT use any water or spray cleaner 

on the transmitter. 

*Store this product in a cool dry place. 

*Replace the batteries in the transmitter when you hear the low battery alarm (beeping sound). If you do not 

replace the batteries in time, you could lose control of your RoboCopter or crash it. 

 

Main parts: 

1. Main 

rotor 

2. Stabilizer 

3. Connecting 

shaft 

4. Tail 

rotor 

5. Charging 

port 

6. Landing 

gear