BMI Technologies Inc. RFVI Manual Do Utilizador
G FORCE PLUS RF Instruction Manual
Apr/08
30
Doc #RF1 Rev.9
c. Complete the fields on the Vehicle Defaults tab. These values will become default values for
Vehicles assigned to this Authorization Group. They can be changed for individual trucks if
required in the Vehicle Settings tab.
required in the Vehicle Settings tab.
Motion Threshold: The sensitivity of the GForce unit to determine if the truck is in
motion or not. A lower number means less acceleration is required to get the GForce to
sense motion.
Motion Interval: The amount of time since the last start, stop, or direction change that
the GForce will consider the truck in motion.
Battery Nominal Voltage: If battery monitoring is enabled, the voltage that is expected
of the battery.
Hard/Soft Threshold: The amount of force, expressed in Gs, it takes for the GForce to
register a Hard/Soft impact.
Hard/Soft Samples: The amount of time (in milliseconds) the hard/soft thresholds need
to be exceeded before the truck goes into Impact Alarm. Do not alter these in most
circumstances.
motion or not. A lower number means less acceleration is required to get the GForce to
sense motion.
Motion Interval: The amount of time since the last start, stop, or direction change that
the GForce will consider the truck in motion.
Battery Nominal Voltage: If battery monitoring is enabled, the voltage that is expected
of the battery.
Hard/Soft Threshold: The amount of force, expressed in Gs, it takes for the GForce to
register a Hard/Soft impact.
Hard/Soft Samples: The amount of time (in milliseconds) the hard/soft thresholds need
to be exceeded before the truck goes into Impact Alarm. Do not alter these in most
circumstances.
3. Click the [OK] button to save the changes.
Create a Vehicle Inspection Checklist
The Vehicle Inspection Checklist for an Authorization Group is created by selecting from a list of 32
system-defined items, as well as adding up to 8 user-defined (custom) items. Each selected item is
displayed on the 2x16-character Vehicle Interface and requires a {Pass} or {Fail} response.
1. Select an Authorization Group from the grid.
2. Click on the Select Inspection List tab at the bottom of the Authorization Group tab.
3. Check the desired system-defined inspection items. These will display on the Vehicle Interface
in the order selected from top left to bottom right.