Galcon Bakarim Agricultural Cooperative Society Ltd G2W3GA Manual Do Utilizador
G2W – Gal 2 Way – Installation and Operation Guide
16
d. Press
until “ADD NEW DEVICES” is displayed on the screen, and press
to select it. The
message “
ENROLL NOW or ENTER ID XX-XXXX” flashes on the screen.
2.
On the field unit you are registering, hold down the registration button (see Figure 1 or Figure 2)
until the red LED turns on. Release the registration button. The station number and the Galileo
number flash on the
until the red LED turns on. Release the registration button. The station number and the Galileo
number flash on the
screen (for example:
“SO1: Galcon RTU, GALILEO NUM: 05”).
3. On the concentrator, press
to confirm registration. The concentrator emits four beeps and the
enrollment message stops flashing.
4. To register additional units, perform the following on the concentrator:
a. Press
. The message “NEXT Device” is displayed on the screen.
b. Press
. The
message “
ENROLL NOW or ENTER ID XX-XXXX” flashes on the screen.
Repeat these sub-steps until you have registered all the field units.
5. After you have registered all the field units, press
to end the registration process and exit to the
main menu.
6. Press
to confirm the registration. The message “DEV UPDATING” is displayed on the screen.
The concentrator emits four beeps and returns to the main display screen.
7. Perform a communications diagnostics test on the registered field units. Refer to Performing
Registering Repeaters
1. On the concentrator, perform the following:
a. Press
until “INSTALLER MENU” is displayed on the screen, and press
to select it.
b. Enter technician code 9999. The concentrator emits four beeps and requests confirmation. Do
not change the technician code.
c. Press
until “DEVICES” is displayed on the screen, and press
to select it.
d. Press
until “ADD NEW DEVICES” is displayed on the screen, and press
to select it. The
message
“ENROLL NOW or ENTER ID XX-XXXX” flashes on the screen.
2.
On the repeater unit you are registering, hold down the registration button (see Figure 1 or Figure 2)
until the red LED turns on. Release the registration button. The station number and the Galileo
number flash on the
until the red LED turns on. Release the registration button. The station number and the Galileo
number flash on the
screen (for example: “
SO1: Gal2Way 2 GALILEO NUM: 09”).
3. On the concentrator, press
to confirm registration. The concentrator emits four beeps and the
enrollment message stops flashing.
4. To register additional units, perform the following on the concentrator:
a. Press
. The message “NEXT Device” is displayed on the screen.
b. Press
. The
message
“ENROLL NOW or ENTER ID XX-XXXX” flashes on the screen.