Axiom Manufacturing Inc 0511AXM0361 Manual Do Utilizador
MC13192U Transceiver Module
User Guide
2
Cautionary Notes:
1) Electrostatic Discharge (ESD) prevention measures should be applied whenever
handling this product. ESD damage is not a warranty repair item.
2) Axiom Manufacturing reserves the right to make changes without further notice to
any products to improve reliability, function or design. Axiom Manufacturing does
not assume any liability arising out of the application or use of any product or circuit
described herein; neither does it convey any license under patent rights or the rights
of others.
not assume any liability arising out of the application or use of any product or circuit
described herein; neither does it convey any license under patent rights or the rights
of others.
3) EMC Information on the MC13192U Module:
a) This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that
may cause undesired operation.
TX FCC ID# TFY1105AXM0361
b) Changes or modifications to this unit not expressly approved by Axiom
Manufacturing, could void the user’s authority to operate this equipment under
FCC or other regulatory agency rules.
FCC or other regulatory agency rules.
c) This product is designed and intended for use as an application platform for
software development in an educational / professional laboratory. Use as a
communication device in end user equipment must follow the recommended
application in this manual.
communication device in end user equipment must follow the recommended
application in this manual.
d) In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate prevention measures.
e) RF Exposure – This device exceeds the FCC requirements for RF exposure when
the antenna used for this transmitter has a separation distance of at least 20cm
from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter.
from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter.
Terminology
This module applies option selection jumpers. Terminology for application of the option
jumpers is as follows:
jumpers is as follows:
Jumper on, in, or installed = jumper is a plastic shunt that fits across 2 pins and
the shunt is installed so that the 2 pins are connected with the shunt.
the shunt is installed so that the 2 pins are connected with the shunt.