Elero USA Inc. 283200902 Manual Do Utilizador

USA-10

USA-9

The following operations are possible using the + and - buttons:

By pressing the MENU button, you can see an overview of the
menu or the operating mode.
The values currently displayed are not saved.

When the RESET button is pressed (with a ballpoint pen or
similar object), the AstroTec reverts to the default setting.

Exceptions: Function, language and city menu levels.

This menu is used to set the time and the date.

W

change value

• Auto mode

W

request information

•  + button

W

next automatic switching time v

•  – button

W

next automatic switching time b

+ button and OK button W astro time v

– button and OK button W astro time b

Note: If you wish to connect a light sensor to the AstroTec 868, the

instructions provided with the light sensor must be followed.

In the “MAN

” sliding switch setting, only manual command

controls are executed.

In the “AUTO

” sliding switch setting, manual and automatic

command controls are carried out (e.g. shade function, time, astro
function,...)

A radio signal is indicated when the transmission control light
comes on.
If the UP, STOP and DOWN buttons or programming button P on the
transmitter are held for a longer period, the transmission control
light will go out after 3, 6 and 9 seconds. This function is a counting
aid. After 12 seconds the transmission control light will go out
completely.
If the batteries are low, the transmission control light flashes during
the transmission process. The transmitter power and/or radio range
is reduced when the batteries are low. If the transmission control
light no longer lights up when a button is pressed, the batteries
have to be replaced.

The time is shown in the display.

When the OK button is pressed, the values currently displayed are
saved.