Hytronik Electronics Co. Ltd HC418VRF Manual Do Utilizador

I –  10%

II –  20%

III – 30%

IV – 50%

This is the time period you would like to keep at the  low light output level before it is completely switched off in the long absence of people. 

I –  0S

II – 10S

III – 1 minute

IV – 5 minutes

V – 10 minutes

VI– 30 minutes

VII– 1 hour

VIII– +∞

+

∞

0S

10S

1min 
5min 

10min 
30min 

1h

I 
II

III

IV

V

VI

VII

VIII

1     2    3

This is the dimmed low light output level you would like to have after the hold-time in the absence of people. 

10%
20%
30%
50%

I  

II 

III 
IV 

1     2   

Using  a screwdriver to adjust the rotary switch on both the master & slave unit, to keep them pointing at the same channel, the grouping is then 

automatically completed. 10 channels (max. 10 groups) available for both the master & slave unit.  

Using a screwdriver to point the arrow to the same position on the master unit and slave units.   

master

slave

5.1 100H burn-in mode for fluorescent lamp
With simple operation, rapidly turn off/on the fixture 3 cycles wihin 3 sec. (the green LED on the sensor flashes and the fixture 

blinks 3 times to indicate the success of setup), lamp will be 100% on for 100 hours, and then automatically goes to sensor mode

after 100 hours. This is crucial to secure the lifetime of fluorescent lamp, when new fixture is installed,or old lamp is replaced.
This 100h burn-in feature can be cancelled by turn off/on the fixture 1 cycle within 1 sec.

With simple operation, rapidly turn off/on the fixture 2 cycles within 2 sec:

a. the green LED on the sensor flashes slowly for 5 seconds, meanwhile the fixture blinks twice.

b. the daylight sensor measures and remembers the surrounding lux for 1 sec.

c. the fixture and green LED is on for 10s to indicate the success of learning.

This feature enables the fixture to function well in any real application circumstance, where the daylight penetrated

into fixture may vary a lot.
The latest surrounding lux value overwrites previous lux value learned. 
Both the setting on DIP switch and the learned ambient lux threshold can overwrite each other.The latest action stays in validity. 

 

 

 

Note: “0s” means on/off control; “+∞” means 2 steps of dimming control, fixture never switch off.