Prime Electronics & Satellitics Inc. WM288P Manual Do Utilizador

 

This is part of a two-machine test. Use the MTS mode “Unicast or Multicast Transmit” on 

another machine to start an Adhoc BSS. (See previous section.) Now, set up the required 

configuration first (make sure the Rx Channel is the same as that on the second machine 

on which a BSS Start was done using Unicast or Multicast Transmit mode). Now push the 

“JOIN” button, whereby after activation, the “No Network” button switches to “Joined…”. 

Now validation over statistics is possible. 

 

 

Note, if “Started !” is displayed instead of “Joined…”, it means either the Rx channel was 

not selected properly or the Adhoc BSS “AMD 802.11 MTS Network” was not started or is 

out-of-range on the second machine. Please click the Join button again to disconnect, 

verify setup and Join again.