Wilson Electronics LLC 460003 Manual Do Utilizador
3
4
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Mon.- Fri. Hours: 7 am to 6 pm MST.
1 . Select a location to install the Signal Booster that is away from
excessive heat, direct sunlight, moisture and has proper ventilation .
Do not place the Signal Booster in an air-tight enclosure .
2 . Select a location on the roof of the building to install the Outside
Antenna . Use a cell phone in test mode to find the strongest signal from
the cell tower . Visit www.WilsonElectronics.com to find test mode
function for your particular cell phone or refer to page 9 .
3 . Run the Outside Antenna cable to the Signal Booster and attach it
to the connector labeled “Outside Antenna” on the Signal Booster .
Run the Inside Antenna cable to the Signal Booster and attach it to
the connector labeled “Inside Antenna” on the Signal Booster (refer
to page 9 for more information on running cable) . Lightning Surge
Protection is recommended for all in-building installations (refer to
page 8) .
4 . Select a location for the Inside Antenna, preferably in the center of where
the signal needs to be amplified . A minimum separation distance of
20
vertical feet (within the null zone) or 50 horizontal feet is necessary
for proper operation . If the inside coverage is not sufficient you may
need as much as
75 feet of horizontal separation (refer to installation
diagram on pages 5 & 6) .
5 . Before powering up the Signal Booster, verify that both the Outside
Antenna and the Inside Antenna are connected and check that all
connections are tight (refer to page 11) .
Note: Be careful when
plugging the connectors in so as not to bend the center pins on the
connectors.
6 . The Signal Booster has been packaged with the gain control knobs
adjusted to the highest gain position . If one or both of the lights are
not green, please refer to pages 12 &13 .
Quick Install Overview
Refer to Installation Diagram on pages 5 & 6 . Contact Wilson Electronics
Technical Support Team with any questions at 866-294-1660 .
Warning: Connecting the Signal Booster directly to a cell phone with
use of an adapter will damage the cell phone and/or the
Signal Booster .
IMPORTANT NOTICE
• It is very important to power your Signal Booster using a surge
protected AC Power Strip with at least a
1000 Joule rating.
• Failure to do this will void your warranty in the event of a power surge
or lightning strike .