Wilson Electronics LLC 460003 Benutzerhandbuch

1 .  Select a location to install the Signal Booster that is away from 

excessive heat, direct sunlight, moisture and has proper ventilation . 

Do not place the Signal Booster in an air-tight enclosure . 

2 .  Select a location on the roof of the building to install the Outside 

Antenna . Use a cell phone in test mode to find the strongest signal from 

the cell tower . Visit www.WilsonElectronics.com to find test mode 

function for your particular cell phone or refer to page 9 .

3 .  Run the Outside Antenna cable to the Signal Booster and attach it 

to the connector labeled “Outside Antenna” on the Signal Booster . 

Run the Inside Antenna cable to the Signal Booster and attach it to 

the connector labeled “Inside Antenna” on the Signal Booster (refer 

to page 9 for more information on running cable) . Lightning Surge 

Protection is recommended for all in-building installations (refer to 

page 8) .

4 .  Select a location for the Inside Antenna, preferably in the center of where 

the signal needs to be amplified . A minimum separation distance of 

20 

vertical feet (within the null zone) or 50 horizontal feet is necessary 

for proper operation . If the inside coverage is not sufficient you may 

need as much as 

75 feet of horizontal separation (refer to installation 

diagram on pages 5 & 6) .    

5 .  Before powering up the Signal Booster, verify that both the Outside 

Antenna and the Inside Antenna are connected and check that all 

connections are tight (refer to page 11) . 

6 .  The Signal Booster has been packaged with the gain control knobs 

adjusted to the highest gain position . If one or both of the lights are 

not green, please refer to pages 12 &13 .

Refer to Installation Diagram on pages 5 & 6 . Contact Wilson Electronics 

Technical Support Team with any questions at 866-294-1660 .

Warning: Connecting the Signal Booster directly to a cell phone with  

 

use of an adapter will damage the cell phone and/or the  

 

Signal Booster .

•  It is very important to power your Signal Booster using a surge 

protected AC Power Strip with at least a 

•  Failure to do this will void your warranty in the event of a power surge 

or lightning strike .