Netgear 06400057 Manual Do Utilizador

2-2

Troubleshooting

If the Power light does not turn solid green within 2 minutes after turning the router on, reset the 
router according to the instructions in 

After you turn on power to the router, the following sequence of events should occur:

1. When power is first applied, verify that the Power light is on (see 

 for an illustration).

2. Verify that the Test light lights within a few seconds, indicating that the self-test procedure is 

running.

3. After approximately 20 seconds, verify that:

a. The Test light turned off.

b. The LAN port lights are lit for any local ports that are connected.

The Internet port is connected and its light is lit.

d. The Wireless port light is lit.

If a port’s light is lit, a link has been established to the connected device. If a LAN port is 
connected to a 100 Mbps device, verify that the port’s light is green. If the port is 10 Mbps, the 
light will be amber.

If the Power and other lights are off, check the following:

•

Make sure that the power cord is properly connected to your router and that the power supply 
adapter is properly connected to a functioning power outlet.

•

Check that you are using the power adapter supplied by NETGEAR for this product.

If the error persists, you have a hardware problem and should contact technical support.