Netgear 10400149 Manual Do Utilizador

Página de 138
N300 WiFi Router (N300R) User Manual
2-18
Safeguarding Your Network
v1.0, May 2012
Connecting Additional Wireless Client Devices after WPS Setup
You can add WPS-enabled and non-WPS-enabled client devices.
Adding Additional WPS-Enabled Clients
To add an additional wireless client device that is WPS enabled:
 or 
.
2. For information about how to view a list of all devices connected to your router (including 
wireless and Ethernet-connected), see 
.
Adding Additional Non-WPS-Enabled Clients
If you are connecting a combination of WPS-enabled clients and clients that are not WPS enabled, 
you cannot use the WPS setup procedures to add clients that are not WPS enabled.
To connect both non-WPS-enabled and WPS-enabled clients to the N300R router:
1. Configure the settings of the N300R router (shown in the Wireless Settings screen) for WPA-
.
When you change security settings, all existing connected wireless clients that do not share 
those settings are disassociated and disconnected from the router.
2. For the non-WPS-enabled devices that you wish to connect, open the networking utility, and 
follow the utility’s instructions to enter security settings.
3. For the WPS-enabled devices that you wish to connect, follow the procedures in 
Note: Your wireless settings do not change when you add an additional WPS-enabled 
client unless you have cleared the Keep Existing Wireless Settings check box (in 
the Wireless Settings screen). If you do clear the check box, a new SSID and a 
passphrase are generated, and all existing connected wireless clients are 
disassociated and disconnected from the router.