ComSonics Inc. 2007VMD Manual Do Utilizador

 

7

 

Install the Antenna 
 

Place the Magnetic Mount Dual Band Antenna on a 
flat roof surface of the vehicle. Position it near as 
possible to the center of the roof away from nearby 
metallic objects; such as other antennas, booms, or 
ladders. Route the cable, perpendicular to the center-
line of the roof, to the point where the antenna cable 
enters the vehicle. Use caution to prevent damage to 
the cable. Coil any excess cable in a loose loop inside 
the vehicle. Secure the cable as needed. 
 
Note: Periodically remove the antenna and clean dust 
and grit from the vehicle surface and bottom of the 
antenna to reduce abrasion to the vehicle finish. 

 
 
Install the Vehicle Mounted Device (VMD) 
 
Check the hardware in your Qualifier 
VMD Installation Kit (part number 
101488-001) to the illustration. 
 

•  Four screws 
•  Power cable 

 
 
 
 
 
Use the hardware contained in the kit to install the VMD as follows: 
 
Place the VMD over the selected mounting location. Allow at least a two inch 
clearance beyond the rear panel for installation of cables. Mark the location of the 
four mounting holes using a center punch. Alternate mounting methods may be 
required in certain installations. 
 
Protect the VMD from debris and use a 1/4-inch nut driver attached to a power 
screwdriver or variable speed drill to install four (4) one-inch self-drilling screws. 
DO NOT OVER TIGHTEN THE SCREWS! Remove any debris remaining from the 
drilling operation. 
 
Connect the antenna cable to the VMD.