Primex Wireless Inc. SSB Manual Do Utilizador
LCD Display
The LCD display of a Smart-Sync Bridge provides a visual reporting of its current operating state - the segments below are displayed
indicating its current state.
Segment
Description
Bton
Indicates the device is in Normal operating mode; allowing its connection to Smart-Sync Bluetooth Network and
Ethernet or Wi-Fi network.
NTP
Indicates its connection to a NTP Server has failed three (3) consecutive times and its UTC time is not accurate.
The red LED flashes during this state.
NoNt
Indicates the device is in No Network mode. During installation, when a network is not available, set the device to No
Network mode to allow its connection to Smart-Sync Clocks over the Smart-Sync Bluetooth Network.
When a network is available, the device must be set back to Normal mode (Bton).
No Signal
Indicates its last connection to an Ethernet or Wi-Fi network failed.
For PoE or Ethernet use, a failed check-in may be due to a network connection cannot be established.
For Wi-Fi network use, a failed check-in may be due to the device is not within range of a wireless signal or the wireless
signal strength is not adequate for normal operation.
If the device is powered by AC or Power over Ethernet (PoE), the yellow LED indicator flashes during this state.
Signal Ok
Indicates its last connection to an Ethernet or Wi-Fi network and check-in to OneVue was successful.
LOW
When operating solely on battery-backup power, indicates its estimated battery life is less than 25%. It's recommended
to replace the batteries.
Lbat
When operating solely on battery-backup power, indicates its battery level is critically low.
Data is not logged or transmitted to OneVue during this state.
Up
A firmware update is being applied to the device.
Data is not logged or transmitted to OneVue during this state.
Con
The device is in configuration mode. The config icon is also displayed.
Data is not logged or transmitted to OneVue during this state.
9
Smart-Sync™ Bridge Install Guide