Mobilicom ltd. MCU-30L Manual Do Utilizador
MCU-30 User Manual
Page : 44 / 51
This page contains information which is protected by copyright and is proprietary to Mobilicom Ltd.
No part of this document
may be used, copied, disclosed or conveyed to another party without prior written consent of Mobilicom Ltd
15.2 Power Cable
Use a cable with 18 AWG gauge (or thicker) wires to connect the PWR connector to
proper terminations that will connect to the DC source. Make sure the grounding pin is
connected to a solid grounding point. The connector on the MCU side is: Hirose
LF10WBRB-4P, On the Cable side it is: Hirose LF10WBP-4S.
proper terminations that will connect to the DC source. Make sure the grounding pin is
connected to a solid grounding point. The connector on the MCU side is: Hirose
LF10WBRB-4P, On the Cable side it is: Hirose LF10WBP-4S.
Figure 22: PWR Connector Front View (MCU-30 side)
MCU-30
LF10WBP-4S
Description
1
GND (-VDC)
2
Vin1 (+VDC)
3
Vin2 (+VDC)
4
GND (-VDC )
Table 7: PWR Connector Type and Pin Mapping