Hewlett Packard Enterprise Company APEX0100101 Manual Do Utilizador

| Installation Guide

The AP-270 Series can be installed on a wall or attached to a pole by using mounting kits:

The grounding must be completed before powering up the AP. The grounding wire should be #8 AWG.

1. Peel the cover of one end of the grounding wire and place the bare grounding wire into the included 

copper lug, and press firmly with the crimping pliers.

2. Fasten the copper lug to the grounding hole on the AP with the included M4 x6 screw as shown in 

. 

Figure 9  Grounding the AP 

To connect the Ethernet cable to the AP, perform the following steps using the cable glands that ships with 
your AP.

Table 4  Applicable Mounting Kits for AP-270 Series

AP-270-MNT-V1

Long mounting kit for wall and vertical pole mounting, 300 mm from vertical mounting 
asset.

AP-270-MNT-V2

Short mounting kit for wall and vertical pole mounting, 75 mm from vertical mounting 
asset.

AP-270-MNT-H1

Mounting kit for hanging from inclined or horizontal structure.

The AP-270 Series access point does not ship with any mounting kits. These mounting kits are available as 

accessories.and must be ordered separately.

For installation instructions on AP-270-MNT-V1, AP-270-MNT-V2 and AP-270-MNT-H1, please refer to the AP-

respectively.

WARNING

Failure to use the included Ethernet cable glands can lead to connectivity and POE issues.