Hewlett Packard Enterprise Company ARUBA70 Manual Do Utilizador

Part 0500044

Installation Guide

October 2004

6

Click  the  Refresh link (not the browser Refresh option) to see if the AP entry has 

displayed.(This might take a moment.)

If you cannot see the entry after 1-2 minutes, click Refresh again.

The Clear Table button appears after an entry in the list appears. 

To erase all the table entries, click Clear Table. (You cannot clear selected entries.) If a 
number of APs are provisioned and you click Clear Table, only the entries which come 
up afterwards can be provisioned.

If the entry does not show up in the AP list, check network connectivity. Go to the AP 
console and verify if the AP has come up with the IP from the provisioning subnet.

7

After the entry shows up on the page, configure the location, Host IP/Name, Master 

IP address.

If AP is going to be assigned a static IP, click Use the following IP Address and enter 
the IP address, Netmask, Gateway IP.

If the AP is going to obtain an IP address using DHCP, click Use IP Address Using 
DHCP.

8

After configuring the required parameters, select the entry from the list (AP to which the 

configuration has to be applied) and click Apply.

The State field changes from U (Unprovisioned) to In Progress.

9

After a few seconds, click the Refresh link again and the State will have changed to P 

(Provisioned).

Note Check that the configured parameters are reflected in the AP list entry.

Note Aruba Networks recommends that you provision each AP for a unique 

location as suggested by site-survey planning. Label each AP with this 
location information and place the AP in its proper location. Failure to 
place APs in the location for which they were provisioned will reduce the 
effectiveness of such RF features as triangulation. 

10 Click Back to go into the previous page

We can see that the Subnet is still configured and Port/s are selected.

11 When finished provisioning APs, click Disable to disable AP Provisioning.