Hewlett Packard Enterprise Company ARUBA70 Manual Do Utilizador

Provisioning Access Points

Chapter 2

From the Aruba 70 console, access the

apboot prompt.

Depending on the Aruba 70 status, you will see one of the following on your terminal:

Autoboot countdown—The countdown prompt allows you to interrupt the normal
startup process and access the

apboot prompt where provisioning is performed.

To access the

apboot prompt, press any key (such as <Enter>) before the timer expires.

If the countdown expires before you can interrupt it, turn the device off and then back on.

TFTP time out—If the Aruba 70 cannot locate an Aruba WLAN Switch on its network
port, the following type of output is repeatedly displayed:

Press <Control-C> to interrupt this process and access the

apboot prompt.

Once the apboot prompt is displayed, perform provisioning as described in the next section.

APBoot 1.2.1 (Apr 7 2004 - 08:54:57)

CPU:   AR2313 MIPS-32 at 180 MHz: 16 kB I-Cache 16 kB D-Cache
Board: Merlot Local Bus at 90 MHz
DRAM:  32 MB
POST: passed
FLASH: 4 MB
Net:   en0 lo0

Hit any key to stop autoboot: 0

Loading FLASH image...
Verifying checksum... failed!
BOOTP broadcast 1
DHCP IP address:   10.1.2.250
DHCP subnet mask: 255.255.255.0
DHCP def gateway: 10.1.2.1
DHCP DNS server:   10.1.1.2
DHCP DNS domain:   arubanetworks.com
DHCP Aruba server: 10.1.2.11
Loading elf file: 10.1.2.11:mips.ari
Loading: T T T T T T T T T
Retry count exceeded; starting again