Hewlett Packard Enterprise Company ARUBA70 Manual Do Utilizador
Provisioning Access Points
21
Chapter 2
Note
The master and serverip environment variables also affect how
source files are selected and should be cleared when using this
approach. To clear a variable, enter the setenv variable command
approach. To clear a variable, enter the setenv variable command
with no host or address value.
When finished, proceed to Step 2.
z
My network uses direct IP addresses instead of DNS.
If using direct IP addresses in your network, use the following commands:
Note
If the servername variable is configured in this scenario, it will be
ignored.
2
Specify an IP address for a specific AP, if necessary.
If using DHCP, the AP will obtain its IP address automatically and you can skip this step.
Otherwise, configure the AP with a static IP address using the following commands:
Otherwise, configure the AP with a static IP address using the following commands:
3
Set the location for the specific AP, if necessary.
Location settings depend on how much control you want over configuring logical groups
of APs in the future.
of APs in the future.
z
Default Locations
If you wish all APs treated as a single entity for configuration and accounting pur-
poses, you can use the default location profile (255.255.65535) and skip to Step 5.
poses, you can use the default location profile (255.255.65535) and skip to Step 5.
apboot> setenv serverip <WLAN switch IP address>
apboot> setenv master <WLAN switch IP address>
apboot> setenv ipaddr <static IP address for the AP>
apboot> setenv netmask <static IP address mask>
apboot> setenv gatewayip <default gateway IP address>
apboot> setenv gatewayip <default gateway IP address>