Hewlett Packard Enterprise Company ARUBA70 Manual Do Utilizador
22
Aruba 70
Part 0500044
Installation Guide
October 2004
Note
If using default locations during initial provisioning, you can later
reconfigure the APs to use specific location IDs using the Aruba
WLAN Switch management tools.
WLAN Switch management tools.
z
Specific Locations
By setting specific location IDs for each AP, you can later apply configuration changes
or collect statistics and information for specific groups of APs (for example, all APs on
a particular floor in a particular building).
or collect statistics and information for specific groups of APs (for example, all APs on
a particular floor in a particular building).
To set a specific location for an individual AP, the following command is used:
setenv location <building number>.<floor number>.<device number>
where the following fields are required:
where the following fields are required:
If you performed the recommended site survey using the Aruba RF Plan tool, the
location data for all access points and air monitors can be found on the tool’s deploy-
ment page (see the Aruba RF Plan User’s Guide).
location data for all access points and air monitors can be found on the tool’s deploy-
ment page (see the Aruba RF Plan User’s Guide).
If you prefer to enter the location data manually, record the location ID you set for
each access point and air monitor along with the following:
each access point and air monitor along with the following:
Building Number
A unique number (1-254) is required for each building in your
campus.
campus.
Floor Number
Within any building, a unique number (1-254) is required for each
floor.
floor.
Device Number
Within any floor, a unique number (1-65534) is required for each
access point or air monitor.
access point or air monitor.