Hewlett Packard Enterprise Company ARUBA70 Manual Do Utilizador

Appendix A

A

PPENDIX

 A

The 10/100 Mbps Ethernet (FE) port is located on the right-hand side of the Aruba 70 and 
has an RJ-45 female connector. The port pin-outs are shown in 

:

A-1 Aruba 70 FE Port>>

The AP can be powered over pins 

1/2, 3/6, 4/5, and 7/8.)- replace graphic<<

The appropriate cable depends on the level of connectivity required of the FE port:

z

If the connecting device supports Serial and Power Over Ethernet (SPOE), use an 
8-conductor, Category 5 UTP, straight-through FE cable with a male RJ-45 connector. (

The Aruba 5000 (with Line Card LC-5000-24FE-2GE-SPOE), the Aruba 2400, and the 
Aruba 800 support SPOE.

z

If the connecting device supports only Power Over Ethernet (POE, including IEEE 
802.3af POE as well as “inline” or “midspan” POE devices), use an 8- or 4-conductor, 
Category 5 UTP, straight-through FE cable with male RJ-45 connectors. 

z

If the connecting device does not support Serial or POE, use a 4- or 8-conductor, 
Category 5 UTP, FE cable with male RJ-45 connectors. The port detects MDI/MDX 
and automatically adjusts for straight-through or crossover cables.

Aruba AP 70

10/100 Mbps Ethernet

RJ-45 Female
Pin-Out

*POE optional

**Serial optional

Serial TxD**    (POE positive*)
Serial TGND**  (POE positive*) 

Serial RxD**   (POE negative*)
Serial RGND**  (POE negative*)

1
2
3
4
5
6
7
8

ETH Rx+  

(POE 

negative*)

ETH Rx–  

(POE 

negative*)

ETH Tx+  

(POE 

positive*)

  (POE positive*     

Direction

Input

Output