Hewlett Packard Enterprise Company MST200DFS Manual Do Utilizador

| Installation Guide

1. Fasten the positioning bracket onto the back of the MST200 using the five M6 x 12 bolts (with flat and 

spring washers). (There is screw thread in the screw hole of the mounting bracket, so nuts are not 
required)

Figure 9  Fastening the positioning bracket to the MST200

2. Use the two M8 x 16 bolts (with flat washers and spring washers) to fasten the positioning bracket 

flanges to the mounting bracket flanges.The flange bolts allow the inclination of the MST200 to be 
adjusted by shifting the angle of the bracket using the fastening bolts as an axis.

Figure 10  Positioning bracket and mounting bracket bolted at flanges

3. Use the four M8 x 110 bolts (with flat washers, spring washers and nuts) and two pole anchors to fasten 

the mounting bracket to the pole.

I

f the pole diameter is larger than 60mm, you can use stainless straps to fasten the MST200 on the pole. To do so, 

pass a strap through the two slots on mounting bracket, attach the mounting bracket (with MST200) to the pole, 

and tighten the strap by using a screw driver to twist its screw head. Use similar straps at the other two slots on the 

mounting bracket.