Hewlett Packard Enterprise Company MST200DFS Manual Do Utilizador
Aruba MST200 Wireless Mesh Router
| Installation Guide
15
Grounding the MST200
The grounding must be completed before powering up the MST200. The resistance of grounding wire
should be less than 5 ohm and the grounding cable’s cross-section area should be no less than 6 square mm.
should be less than 5 ohm and the grounding cable’s cross-section area should be no less than 6 square mm.
Figure 13 Grounding the MST200
1. Peel the cover of one end of the grounding cable (green or yellow and green grounding cable with 6
square mm cross-section area) and place the bare grounding cable into the copper lug, and press firmly
with the crimping pliers.
with the crimping pliers.
2. Fasten the copper lug to the grounding hole on the MST200 with the M4 x12 bolt and external-tooth
washer.
Connecting the Ethernet Cable
To ensure that your MST2HP maintains Ethernet connectivity and Power over Ethernet (PoE), you must
use the included weatherproof connector kit and install it using the steps described in
use the included weatherproof connector kit and install it using the steps described in
Figure 14 Waterproof Ethernet Connector Kit
Failure to use the included weatherproof connector kit can lead to connectivity and PoE issues.
Table 5
1
Shielded RJ45 connector
4
Locknut
2
Gasket Mat
5
Seal Ring