Hewlett Packard Enterprise Company MST200DFS Manual Do Utilizador

| Installation Guide

1. Place the locknut over the weatherproof connector socket.

2. Place the sealing nut over an ethernet cable (without a connector attached to the end).

3. Place the seal ring over the ethernet cable.

4. Insert the ethernet cable into the narrow end of the weatherproof connector socket and pass it through 

the opening on the wide end.

5. Using a crimping tool, attach the included shielded RJ45 connector.

6. Slide the seal ring up the ethernet cable and insert it into the narrow end of the weatherproof connector 

socket.

7. Pull the ethernet cable so the shielded RJ45 connector fits into the RJ45 shaped opening in the wide end 

of the weatherproof connector socket.

8. Slide the sealing nut over the narrow end of the weatherproof connector socket and hand tighten it.

9. Insert the ethernet cable connector into the Ethernet interface and hand-tighten the locknut.

10. Water-proof the Ethernet cable connection with electrical tape and butyl rubber. (Detailed steps please 

see the 

"Weatherproofing Connections" on page 12

 in this guide)

Figure 15  Connecting the Ethernet cable

3

Waterproof Connector Socket

6

Sealing Nut

For outdoor use, the RJ45 must be installed with a waterproofing gasket. 

The Ethernet cable and power cable need proper drip loops. Drip loops prevent water from entering the router 

through the connectors.

It is recommended to fix the Ethernet cable near the MST200 side to the wall or the pole. This is to ensure that the 

weight of the cable does not affect the RJ45 connector.