Redline Communications Inc. AN100UXA Manual Do Utilizador
User
AN-100U/UX Base Station
Manual
70-00058-01-04
Proprietary Redline Communications © 2010
Page 74 of 136
April 19, 2010
Default Service Flows
Use the following fields to configure operation of the default uplink and downlink service
flows. Learning is enabled for default service flows.
flows. Learning is enabled for default service flows.
Default UL SF Enable: Check this box ( ) to enable the default UL service flow.
Default DL SF Rate (bps): Enter the maximum rate for the default DL service flow.
DL Source MAC Address: Enter the MAC address of the aggregator. Only traffic
received from the specified aggregator is forwarded to subcribers.
received from the specified aggregator is forwarded to subcribers.
DL Source MAC Mask: Enter the mask value (hex) use with DL Source MAC Address.
1. A mask value of all ones (ff:ff:ff:ff:ff:ff) will match only the MAC address entered in the
DL Source MAC Address field.
DL Source MAC Address field.
2. A partially specified mask value will match a range of MAC addresses. For example, a
mask value of 01:02:03:ff:ff:ff will match all MAC addresses where the first 48 bits are
01:02:03. The should be set to all zeros.
mask value of 01:02:03:ff:ff:ff will match all MAC addresses where the first 48 bits are
01:02:03. The should be set to all zeros.
3. A mask of all zeros (00:00:00:00:00:00) will match all destination MAC addresses (DL
Source MAC Address field is ignored).
Source MAC Address field is ignored).
Miscellaneous
Show SS MAC Address Check this box ( ) to display the subscriber MAC address on
the SF Info screen and in log messages. When this selection is not active, the subscriber
name is displayed on the SF Info screen and in log messages.
the SF Info screen and in log messages. When this selection is not active, the subscriber
name is displayed on the SF Info screen and in log messages.
Controls
Save: Click
Save
to apply and save the displayed settings. Changes to settings marked
with a red asterisk (
*
) are effective only after the base station is rebooted.
Cancel: Click
Cancel
to discard all changes and return to the main screen.
Default: Click
Default
to set all settings to the factory default settings.