Redline Communications Inc. AN100UXA Manual Do Utilizador
User
AN-100U/UX Base Station
Manual
70-00058-01-04
Proprietary Redline Communications © 2010
Page 75 of 136
April 19, 2010
4.5.2 Software Upgrade
Click
Software Upgrade
in the menu (left side of screen) to upload a new system
software image from a remote server. The terminal contains two non-volatile RAM banks
for storing the software. Each upload overwrites the standby (unselected) bank.
for storing the software. Each upload overwrites the standby (unselected) bank.
Figure 34: Web: Admin Tools - Software Upgrade Screen
Upgrading Software
Protocol: Select the type of server:
FTP: Use File Transfer Protocol for file upload.
TFTP: Use Trivial File Transfer Protocol for file upload. TFTP is not available in the
current software version.
current software version.
Server IP Address: Enter the FTP server network address.
User: Enter the username of a user that is defined on the FTP server and has sufficient
access rights to the base station software image file.
access rights to the base station software image file.
Password: Enter the password for the username entered in the User field above.
File Path: Enter the path and name of the system software image to upload. It is
strongly recommended to copy the binary files to the default file directory for the FTP
server and to specify only the file name in this field.
strongly recommended to copy the binary files to the default file directory for the FTP
server and to specify only the file name in this field.
Status: Monitors the software upload operation.
Start Upgrade: Click
Start Upgrade
to begin the software upload.
Active SW Selection
Version: Select the software image to load on the next system reboot.
Status: Monitors the system upgrade operation.
Apply&Reset: Click
Apply&Reset
to save the current version selection and reboot the
base station.
Before Beginning the Upgrade
Use the following procedures to upgrade the base station.
The following items must be addressed before beginning the upgrade: