Falcom GmbH STEPPII-56 Manual Do Utilizador
STEPP II HARDWARE DESCRIPTION VERSION
1.01
Normally the GPS antenna must be placed in a position where it can see the
sky. To get a valid position, the STEPP II should get information from at
least 3 satellites.
The STEPP II supports two software (known as “firmware”).
sky. To get a valid position, the STEPP II should get information from at
least 3 satellites.
The STEPP II supports two software (known as “firmware”).
Depending on the configuration, the device exchanges data with a
server application (e.g. Mapping-Software, etc.). The STEPP II can be
configured by the user via local RS232-interface or remotely over the
GSM (air link see diagram marked ). This configuration is based on
the STEPP II operating with firmware version 1.6.2. Please, refer to
the issued manual “
configured by the user via local RS232-interface or remotely over the
GSM (air link see diagram marked ). This configuration is based on
the STEPP II operating with firmware version 1.6.2. Please, refer to
the issued manual “
stepp_II_software_1.6.2_manual.pdf
”.
The STEPP II terminal supports a firmware, using TCP/IP stack and
PPP protocol, according to the user configuration, terminal is able to
establish a GPRS data connection. Via GPRS (see diagram marked )
it is possible that the vehicle's current location can be polled and
displayed or the vehicle can be tracked "live" second by second on a
mapping software. This configuration is based on the STEPP II
operating with firmware version 2.0RC1. The firmware version
2.0RC1 is under development, however, for the end-user FALCOM
releases the first version. This firmware version provides limited TCP
commands (so far limited configuration, a full configuration is in
preparation). Please, refer to the issued manual
“
establish a GPRS data connection. Via GPRS (see diagram marked )
it is possible that the vehicle's current location can be polled and
displayed or the vehicle can be tracked "live" second by second on a
mapping software. This configuration is based on the STEPP II
operating with firmware version 2.0RC1. The firmware version
2.0RC1 is under development, however, for the end-user FALCOM
releases the first version. This firmware version provides limited TCP
commands (so far limited configuration, a full configuration is in
preparation). Please, refer to the issued manual
“
stepp_II_software_2.0RC1_manual.pdf
”.
This confidential document is a property of FALCOM GmbH and may not be copied or circulated without previous permission.
Page 22