HIMS International Corporation B14K Manual Do Utilizador

2.  Connecting via Bluetooth to a Windows 7/Windows 8 computer. 

1) Open the Control Panel. 

2) Open Devices and Printers 

3) Tab to "Add a Device" and press "Enter". 

4) Windows searches for devices and displays them in a list. 

5) Use the Up or Down arrow to navigate to the Smart Beetle and 
press "Enter". 

6) You are asked to enter the pass code for the device. Enter a 4 
digit code of your choosing and press Enter. The Smart Beetle will 
then prompt you for the same pass code; type it in computer 
Braille, and press Enter. 

7) The computer should display the message, "Found new 
hardware" and the final dialog should appear on the computer. The 
dialog should display that the Bluetooth device was successfully 
set up. It is very important to note the Bluetooth COM port as you 
will need this when setting up your screen reader. 

   

4.3 Using the Smart Beetle with Window-Eyes 

 Use the following steps to connect your HIMS Braille device as a 
terminal for Screen Reader with Window-Eyes from GW Micro. 

1)  Make sure your Smart Beetle is powered on, and in "Pairing BRL" 
or "USB" mode. 

2)  Press Control-Backslash to open the Window-Eyes control Panel. 

3)  Arrow down to devices and press "Enter". 

4) Arrow down to "Braille displays" and press "Tab" to open the 
available displays list. 

5)  Arrow down to Smart Beetle and press "Tab" to get to the ports 
list. 

6)  If you are using Bluetooth, please choose the Com Port number 
that matches your Bluetooth connection. If using USB, choose "USB" 
from the ports list. 

7)  Tab to "Activate" and press "Enter". 

8) If activation is successful, you have 15 seconds to choose 
whether or not to "keep settings" or "Revert" the settings to the way 
they were before you activated the Smart Beetle.