3e Technologies International Inc. 523E-900 Manual Do Utilizador
AirGuard WiMesh 3e-
523 Series User’s Guide
Copyright
2015 Ultra Electronics, 3eTI
October 2015
41
29000169-005 Revision C1
NOTES & TIPS
1. Most (not all) switch vendors treat VLAN 1 as an untagged VLAN. 3eTI devices make the VLAN 1
tag rule a user option. By default, 3eTI treats VLAN 1 as an untagged VLAN. It is recommended
that users keep the same default setting for all devices in the same physical network.
that users keep the same default setting for all devices in the same physical network.
2.
“Treat VLAN 1 Untagged” setting is a device-wide option. The rule applies to all interfaces that are
configured to be on VLAN 1. For example, if this option is enabled, management traffic from this
device Also, wireless client traffic on VLAN 1 won’t have tag.
configured to be on VLAN 1. For example, if this option is enabled, management traffic from this
device Also, wireless client traffic on VLAN 1 won’t have tag.
3.
It’s always recommended to manage the device through the LAN virtual interface (192.168.15.1)
when local access is available for the device. The LAN virtual interface is helpful especially when:
when local access is available for the device. The LAN virtual interface is helpful especially when:
o A device IP address is unknown.
o The device has not obtained an IP address from a DHCP server.
o The Management VLAN is tagged.
2.3.8 AP MAC Filtering
The Wireless Access Point - MAC Filtering screen (
Figure 36) is used to set up MAC address filtering for 3e
–523 devices. The factory default for MAC
Address filtering is Disabled. If you enable MAC Address filtering, you should also set the toggle for Filter
Type.
Type.
Figure 36 - Wireless Access Point - MAC Filtering
MAC Filtering works as follows: