FreeWave Technologies Inc. 42182112519 Manual Do Utilizador
Spread Spectrum Modem Wireless Data Transceiver Installation Guide
LIG0003AD Rev A
Version 6.0
4
A. Transceiver installation steps
To install the FGR2 series transceivers, follow the basic steps given below.
1.
Mount the transceiver to the flat, stable surface using mounting holes in the corners of the
transceiver. Transceiver models sold under FCC ID KNY- 42182112519 are to be installed
professionally in NEMA enclosures.
transceiver. Transceiver models sold under FCC ID KNY- 42182112519 are to be installed
professionally in NEMA enclosures.
2.
Install the antenna and connect the antenna feed-line to the transceiver. If installing a
directional antenna, preset the antenna’s direction appropriately. The antenna must be
professionally installed on a fixed-mounted permanent outdoor structure for satisfying RF
exposure requirements.
directional antenna, preset the antenna’s direction appropriately. The antenna must be
professionally installed on a fixed-mounted permanent outdoor structure for satisfying RF
exposure requirements.
3.
Connect the serial port of a computer to the transceiver’s RS232 port (please refer to the part
C of this addendum for more information about the transceiver’s pin assignment). This
computer will be used to set the radio’s configurations.
C of this addendum for more information about the transceiver’s pin assignment). This
computer will be used to set the radio’s configurations.
4.
Install the power for the radio.
5.
Set the radio configuration according to the system topology and data terminal equipment
requirements. Default transceiver settings allow user to do a quick installation without major
changes in transceiver’s configuration. However, there is one parameter that must be
considered for a new installation – the transceiver’s power output setting.
requirements. Default transceiver settings allow user to do a quick installation without major
changes in transceiver’s configuration. However, there is one parameter that must be
considered for a new installation – the transceiver’s power output setting.
Transceiver
output power level must be set according to the tables given below to satisfy the FCC
maximum EIRP requirement. Per FCC regulations, any antenna used with FreeWave
transceivers must either be one of the approved antennas shown below or an antenna
approved by FreeWave Technologies with comparable performance parameters. FreeWave
Technologies offers a variety of Omni-directional and directional external antennas, with both
bracket and magnetic mounts. The complete list of antennas available from FreeWave
Technologies including antenna gains, antenna manufacturer’s information and antenna’s
characteristics are shown below:
maximum EIRP requirement. Per FCC regulations, any antenna used with FreeWave
transceivers must either be one of the approved antennas shown below or an antenna
approved by FreeWave Technologies with comparable performance parameters. FreeWave
Technologies offers a variety of Omni-directional and directional external antennas, with both
bracket and magnetic mounts. The complete list of antennas available from FreeWave
Technologies including antenna gains, antenna manufacturer’s information and antenna’s
characteristics are shown below:
The following antennas are approved for use with FreeWave transceivers:
900MHz Directional Antennas
Gain
Manufacturer
Manufacturer
Model Number
FreeWave
Model Number
11dBi Larsen
YA5900-W
EAN0900YA
10dBi BlueWave
BMY890K5502N4
EAN0900YC
6dBI BlueWave
BMY890G5502N4
EAN0906YC
6dBi Larsen
YA6-900
EAN0906YA