Cameo Communications Inc DSLR2001N Manual Do Utilizador
Advanced
TRENDnet
DSLR-2001N
65
6.8
Packet Filter
Filters & Rules
This page allows you to create packet filters and rules. These
filters are used to check each data that passes within your
network. If the packet data does not meet the requirements, the
packet is either dropped or rejected.
filters are used to check each data that passes within your
network. If the packet data does not meet the requirements, the
packet is either dropped or rejected.
To access the Filters & Rules page, click ADVANCED > Packet Filter
> Filters & Rules or click the Filters & Rules button.
> Filters & Rules or click the Filters & Rules button.
Filters
Click the Add button to create a new filter.
Name — Enter desired filter name.
☞
NOTE: The filter name cannot contain spaces.
Interface — Select the interface to implement the filter.
Type — Select In to filter incoming packets or select Out to
filter outgoing packets.
filter outgoing packets.
Default Action — Select Drop to drop the packets or select Permit
to allow packets to pass through if the rule requirement is met.
to allow packets to pass through if the rule requirement is met.
Click the Apply button to save the filter or click the Cancel
button to discard your changes.
button to discard your changes.
The new entry is listed on the FILTERS table. An Index and Key are
automatically assigned to each filter that you create. The Key is
used to identify the filter when assigning rules.
automatically assigned to each filter that you create. The Key is
used to identify the filter when assigning rules.
To edit a filter, click the corresponding
icon. To delete a
filter, click the corresponding icon.