DeHaardt Electronic Engineering B.V. 69112201 Manual Do Utilizador
Manual timing & identification system using EP-30 & BP-60
4
9.
Printer
10.
PC
2 Installation
2.1 Detection antenna mounting
Every time when a go-kart is right above the detection antenna, the detection antenna picks up
the signal of the passing transponder. This signal is fed into the coax cable, which connects
the detection antenna to the timing and identification decoder.
the signal of the passing transponder. This signal is fed into the coax cable, which connects
the detection antenna to the timing and identification decoder.
2.2 Mounting of detection antenna in the circuit
The detection antenna is placed inside a groove in the surface of the track and positioned in
such a way that the timing transponder is in the middle above the detection antenna when the
front of the go-kart is above the finish line.
such a way that the timing transponder is in the middle above the detection antenna when the
front of the go-kart is above the finish line.
For the mounting of the detection antenna, it is necessary to make 2 grooves, 65cm / 2 ft
apart, over the full width of the track ( maximum 10m / 33 ft ). The cutting depth of the
groove must be 15mm - 5/8” and 3mm – 1/8” width. The detection antenna is placed in the
rectangle shaped groove and filled with silicon.
Be sure that the sharp groove corners do not cut the detection antenna wire.
apart, over the full width of the track ( maximum 10m / 33 ft ). The cutting depth of the
groove must be 15mm - 5/8” and 3mm – 1/8” width. The detection antenna is placed in the
rectangle shaped groove and filled with silicon.
Be sure that the sharp groove corners do not cut the detection antenna wire.