DeHaardt Electronic Engineering B.V. 69112201 Manual Do Utilizador
Manual timing & identification system using EP-30 & BP-60
6
Transponder number
Pass time
Hits
( Number of times the transponder is
detected during the passing )
Signal level
( Received signal strength of the
transponder )
Detection antenna number
Total number of detected transponders
With the function button on the front side of the timing and identification decoder, a selection
between the 2 display modes can be made.
between the 2 display modes can be made.
Passing transponder information ( Selected at power-up )
Detection antenna quality information
Pressing down the function key and releasing it at the moment the display shows the correct
information makes the mode selection.
information makes the mode selection.
2.6 Transponder mounting on go-karts
Each go-kart becomes its own timing transponder,
which can be powered directly from the Honda GX … (
or compatible ) engine.
which can be powered directly from the Honda GX … (
or compatible ) engine.
It is very important that the installation of the timing
transponder on the go-kart is done according the
descriptions below, else a serious degradation of
performance can occur.
transponder on the go-kart is done according the
descriptions below, else a serious degradation of
performance can occur.
The 3 most important installation rules are:
1.
The maximum distance between the detection antenna and the middle of the timing
transponder housing, is 20 cm – 2/3 ft.
2.
The bottom and topside of the timing transponder must be free of electrical conductive
materials. Also between the transponder and detection antenna, no electrical conductive
materials are allowed.
materials are allowed.
3.
The timing transponder mounting direction must be done according the following
description :
When the timing transponder is assembled on horizontal (for example on a plastic
When the timing transponder is assembled on horizontal (for example on a plastic
floor plate of the go-kart), the mounting direction is not important.
As soon as the timing transponder is vertically mounted (for example on the back of
the seat), then the identifier of the transponder must facing forwards or backwards. So
for example a transponder mounted on the side-pots of the go-kart, facing to the seat,
will perform very badly!
for example a transponder mounted on the side-pots of the go-kart, facing to the seat,
will perform very badly!
It is advisable to first connect the timing transponder to one go-kart only, then test if it works
correctly, and then continue to mount the timing transponders to all other go-karts. The testing
is very easy. Drive with the test go-kart a few times across the detection antenna, and every
correctly, and then continue to mount the timing transponders to all other go-karts. The testing
is very easy. Drive with the test go-kart a few times across the detection antenna, and every