Adtran TRC4208 Manual Do Utilizador

Página de 60
TRACER 4208 System Manual
Section 2  Microwave Path Engineering Basics
612804208L1-1A
© 2003 ADTRAN, Inc.
17
Figure 1.  Example Microwave Path with Parameters
The following sections further discuss the power budget analysis and its components.
Antenna Gain
Actual transmit and receive antenna gain values depend strictly upon the physical characteristics of the 
antennas installed for each link. In other words, the size of the dish determines the antenna gain. Using a 
parabolic dish antenna results in the best performance. Antenna gains are specified in terms of decibels of 
gain referenced to an isotropic source (dBi). An isotropic source is a hypothetical antenna having equal 
radiation in all directions. Typical antenna gains are listed in Table 1; however, dish manufacturers can 
provide gains for specific types of antennas.
Transmitted Power (P
T
)
The FCC specifies the maximum transmitter power used for antennae of a given gain. FCC Rules Part 15, 
Subpart 247 allow for a maximum power of 1 Watt (30 dBm) into antennae of a gain less than or equal to 
6 dBi. Since the TRACER 4208 maximum transmit power is 100 milliwatts, there is no reduction in 
transmitter output power required for antennae gains greater than 6 dBi.
Table 1.   Antenna Gain for Given Dish Diameters
Dish Diameter
(in feet)
Gain at 5.8 GHz
(in dBi)
2
28.5
4
34.2
6
37.5
8
40.7
10
42.5
12
44.2
 
G
T
G
R
d, L
P
P
T
P
R
λ
L
L