Adtran TRC6320 Manual Do Utilizador
TRACER 6000 Series Split System Manual
Section 5 User Interface Guide
612806320L1-1A
65
> RF L
INK
C
ONFIGURATION
> RF B
AND
P
LAN
Sets the band plan for the TRACER. Each channel is divided into three band plans (1, 2, or 3). Both local
and remote TRACER must be configured with the same band plan (1, 2, or 3) but different channel plans
(A or B). For example, the transmitter at one end of the link will transmit in band plan 1 of channel A (the
lower portion of the spectrum) and receive in band plan 1 of channel B (the upper portion). Consequently,
the receiver at the other end should receive in band plan 1 of channel A (the lower portion) and transmit in
band plan 1 of channel B (the upper portion). (Refer to Figure 6 for the division.) The TRACER comes
factory programmed with RF band plan set to Band 1.
and remote TRACER must be configured with the same band plan (1, 2, or 3) but different channel plans
(A or B). For example, the transmitter at one end of the link will transmit in band plan 1 of channel A (the
lower portion of the spectrum) and receive in band plan 1 of channel B (the upper portion). Consequently,
the receiver at the other end should receive in band plan 1 of channel A (the lower portion) and transmit in
band plan 1 of channel B (the upper portion). (Refer to Figure 6 for the division.) The TRACER comes
factory programmed with RF band plan set to Band 1.
Figure 6. 5.8 GHz Bandwidth Division
> RF L
INK
C
ONFIGURATION
> L
INK
E
NCRYPTION
The TRACER 6200 provides triple-DES (3DES) encryption of the data passed over the RF Link. When
L
INK
E
NCRYPTION
is set to
E
NABLED
, the system sequentially applies the three keys entered in the
S
UBKEY
0
,
1
, and
2
fields to each 64-bit block of data transmitted over the RF link. The remote system uses the same
keys to decrypt each block. (The keys entered in the local and remote systems must be identical.)
> RF L
INK
C
ONFIGURATION
> S
UBKEY
(0-2)
The TRACER 6200 provides 3DES encryption of the data passed over the RF Link. When
L
INK
E
NCRYPTION
is set to
E
NABLED
, the TRACER sequentially applies the three keys entered in the
S
UBKEY
0
,
1
, and
2
fields to each 64-bit block of data transmitted over the RF link. The remote system uses the same
keys to decrypt each block. (The keys entered in the local and remote systems must be identical.) Valid
entries are numbers
entries are numbers
0
through
9
and letters a through f.
When changing RF band plans on installed links, change the remote end first. If the local
end is changed first, remote configuration capability is lost. In the event the local end is
changed first and the link is dropped, reset the local end to the previous setting to restore
the link.
end is changed first, remote configuration capability is lost. In the event the local end is
changed first and the link is dropped, reset the local end to the previous setting to restore
the link.
Channel A
5744
5725
5787
58
5747
5751
MHz
Band plan 3
Band plan 2
Band plan 1
Channel B
5824
5827
5831
Band plan 3
Band plan 2
Band plan 1