Adtran TRC6320 Manual Do Utilizador

Section 5  User Interface Guide

TRACER 6000 Series Split System Manual

 72

612806320L1-1A

When 

, the receiver detects the CRC-4 checksum bits in the outgoing E1 data stream and checks 

the received signal for errors.

Configures the framing format for the E1 link. The TRACER transports E1 data across the link (as long as 
the E1 signal is properly timed). Configure the framing format (using the 

 menu) to enable the 

TRACER to monitor incoming framing error events and indicate problems with the attached metallic 
service. The TRACER supports 

 (also known as CAS), 

 (all data stream with no 

framing sequence bits), and 

 (also known as CCS). The default value is 

.

Sets the line coding for the E1 link. The TRACER supports high-density bipolar 3 substitution (

) and 

alternate mark inversion (

) line coding. HDB3 coding does not allow more than three consecutive 

zeros in a transmitted bit stream and is the standard coding method on public networks. 

Controls the loop status of the E1 link. Activates/deactivates loopback conditions for testing purposes.

Defines the E1 link as normal data transport mode; there are no active loopbacks.

Activates a loopback at the local TRACER E1 framer towards the remote end of the wireless link (see 
Figure 14). Use the local 

 loopback to loop the data transmitted from the remote end of the link back 

across the radio link to the remote end of the link. This loopback tests the integrity of the radio link and all 
the associated digital and RF hardware.

Activates a loopback at the remote TRACER E1 framer towards the local end of the wireless link (see 
Figure 15). Use the remote 

 loopback to loop the data transmitted from the local end of the link across 

the radio link to the local end of the link. This loopback tests the integrity of the radio link and all the 
associated digital and RF hardware.