Adtran TRC6320 Manual Do Utilizador

TRACER 6000 Series Split System Manual

Section 5  User Interface Guide

612806320L1-1A

81

Figure 30 shows the Management/SNMP Port Configuration menu page, which contains the configuration 
parameters for the 10/100BaseT/TX 

 Ethernet interface and SNMP configuration parameters (from 

both the local and remote TRACER units). 

Lists the address assigned to the 10/100BaseT/TX 

 Ethernet port. This address is in dotted decimal 

notation (four decimal numbers, each in the range of 0 to 255, separated by periods). This value is set to 

 by default. Obtain the correct IP address from your LAN administrator.

Defines which part of a destination IP address contains the network number. This address is in dotted 
decimal notation (four decimal numbers, each in the range of 0 to 255, separated by periods). This value

 

is set to 

 by default. This part of the destination IP address is used along with the

 

TRACER IP address to determine which nodes must be reached through the default IP gateway.

Defines or changes the default gateway. You will need a default gateway if the LAN contains multiple 
segments. This address is in dotted decimal notation (four decimal numbers, each in the range of 0 to 255, 
separated by periods). This value is set to 

 by default. Contact your LAN administrator for 

the appropriate address.

(Read Only) Displays the system Ethernet Media Access Control (MAC) address.