Adtran TRC6410 Manual Do Utilizador
TRACER 6000 Series Integrated System Manual
Section 2 Microwave Path Engineering Basics
612806420L1-1D
Copyright © 2005 ADTRAN, Inc.
25
Antenna Beam Patterns
Antennas used with the TRACER 64x0 system have a particular beam shape, determined in part by the
physical construction and geometry of the antenna. The antenna beam patterns are characterized by a
dominant main lobe, which is the preferred lobe to use for point-to-point communications, and several side
lobes, as shown in Figure 2. When setting up a microwave link, antenna alignment is nothing more than
steering the main lobes of both antennas until the main lobe of one transmitter is centered on the receiving
element of the receiving antenna.
physical construction and geometry of the antenna. The antenna beam patterns are characterized by a
dominant main lobe, which is the preferred lobe to use for point-to-point communications, and several side
lobes, as shown in Figure 2. When setting up a microwave link, antenna alignment is nothing more than
steering the main lobes of both antennas until the main lobe of one transmitter is centered on the receiving
element of the receiving antenna.
Figure 2. Typical Antenna Beam Pattern
Antennas are also designed to radiate RF energy efficiently for a specific range of frequencies. Please
consult the data sheet for your particular antenna make and model to ensure that it is specified to operate in
the 2400 MHz to 24835 MHz (TRACER 6410) or 5725 MHz to 5850 MHz (TRACER 6420) frequency
bands for your TRACER 64x0 system.
consult the data sheet for your particular antenna make and model to ensure that it is specified to operate in
the 2400 MHz to 24835 MHz (TRACER 6410) or 5725 MHz to 5850 MHz (TRACER 6420) frequency
bands for your TRACER 64x0 system.
Fresnel Zones, Earth Curvature, and Antenna Heights
Fresnel zones correspond to regions in the microwave path where reflections of the intended signal occur
and combine in both constructive and destructive manners with the main signal, thereby either enhancing
or reducing the net power at the receiver.
and combine in both constructive and destructive manners with the main signal, thereby either enhancing
or reducing the net power at the receiver.
In general, the odd numbered Fresnel zones (1, 3, 5, ...) add constructively at the receiver, while the even
numbered Fresnel zones (2, 4, 6, ...) add destructively at the receiver.
numbered Fresnel zones (2, 4, 6, ...) add destructively at the receiver.
The first Fresnel zone corresponds to the main lobe, 60 percent of which must be free of physical
obstructions for the path calculations to be valid. Since the main lobe contains the vast majority of the
microwave energy, this zone is typically used to determine proper antenna heights when placing antennas
on towers or buildings.
obstructions for the path calculations to be valid. Since the main lobe contains the vast majority of the
microwave energy, this zone is typically used to determine proper antenna heights when placing antennas
on towers or buildings.
The curvature of the Earth becomes a legitimate obstruction for path lengths of 7 miles (11 kilometers) or
greater, and must also be accounted for when determining minimum antenna heights.
greater, and must also be accounted for when determining minimum antenna heights.
The aggregate expression for minimum antenna height that incorporates both the 60 percent first Fresnel
zone and the Earth’s curvature is given by
zone and the Earth’s curvature is given by
main lobe
side lobes
h
72.1
d
4f
-----
0.125d
2
+
=
(feet)