Adtran TRC6420 Manual Do Utilizador
TRACER 6420 System Manual
Section 4 Network Turnup Procedure
612806420L1-1A
Copyright © 2005 ADTRAN, Inc.
41
8.
INSTALLING MODULES
Figure 4 shows the slot numbering designation as viewed from the rear of the TRACER 6420. The
functionally identical option slots only accept TRACER network modules.
functionally identical option slots only accept TRACER network modules.
Figure 4. TRACER 6420 Network Module Slot Designation
Instructions for Installing Network Modules
Individual access modules insert in the back of the chassis. Two Phillips-head screws hold the modules in
place for added security. To install network modules, follow the steps outlined below.
place for added security. To install network modules, follow the steps outlined below.
Access modules are intended to be serviced by qualified service personnel only
Electronic modules can be damaged by static electrical discharge. Before handling
modules, put on an antistatic discharge wrist strap to prevent damage to electronic
components. Place modules in antistatic packing material when transporting or storing.
When working on modules, always place them on an approved antistatic mat that is
electrically grounded.
modules, put on an antistatic discharge wrist strap to prevent damage to electronic
components. Place modules in antistatic packing material when transporting or storing.
When working on modules, always place them on an approved antistatic mat that is
electrically grounded.
Step
Action
1.
Remove power from the unit.
2.
Slide the network module into the network slot until the module is firmly seated
against the front of the chassis.
against the front of the chassis.
3.
Secure the screws at both edges of the module.
4.
Connect the cables to the associated device(s).
5.
Restore power to the unit.
MODULE 1
MODULE 2