Adtran TRC6420L2X Manual Do Utilizador
612806420L1-1E
Copyright © 2005 ADTRAN, Inc.
107
DLP-6
Updating the Firmware Using XMODEM
Introduction
The TRACER 64x0 supports firmware updates of the local and remote systems using TFTP or XMODEM.
Use the 10/100BaseT/TX
Use the 10/100BaseT/TX
MGMT
port and TFTP from a network server or XMODEM (if your Telnet client
supports file transfers), or use XMODEM and the
CRAFT
interface. This procedure outlines the steps for a
successful firmware upgrade using the
CRAFT
interface and XMODEM software. The same XMODEM
steps apply for file transfers through your Telnet client (refer to your Telnet client documentation for more
details on file transfer specifics). (See DLP-5, Updating the Firmware Using TFTP, on page 103 for
instructions on using TFTP.)
details on file transfer specifics). (See DLP-5, Updating the Firmware Using TFTP, on page 103 for
instructions on using TFTP.)
Tools and Materials Required
•
VT100 terminal or PC with VT100 terminal emulation software
•
XMODEM software
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm
lightning storm
Electronic equipment can be damaged by static electrical discharge. Before handling it,
put on an antistatic discharge wrist strap to prevent damage to electronic components.
Place equipment in antistatic packing material when transporting or storing. When
working on equipment, always place it on an approved antistatic mat that is electrically
grounded.
put on an antistatic discharge wrist strap to prevent damage to electronic components.
Place equipment in antistatic packing material when transporting or storing. When
working on equipment, always place it on an approved antistatic mat that is electrically
grounded.