Adtran TRC6420L2X Manual Do Utilizador
612806420L1-1E
Copyright © 2005 ADTRAN, Inc.
91
DLP-1
Connecting a VT100 Terminal or PC to the CRAFT Port
Introduction
TRACER 64x0 management and provisioning are facilitated by a series of intuitive menus that are
accessible on a computer screen. Connecting either a VT100 terminal or a PC with terminal emulation
software to the
accessible on a computer screen. Connecting either a VT100 terminal or a PC with terminal emulation
software to the
CRAFT
interface (DB-9) on the front of the unit allows access to TRACER menus and
management features. This section specifies how to connect the VT100 terminal or PC to the TRACER
64x0.
64x0.
Prerequisite Procedures
The TRACER 64x0 must be powered up for terminal communication to function.
Tools and Materials Required
•
A VT100 compatible terminal or PC with terminal emulation software
•
An appropriate cable to connect the TRACER 64x0 to a terminal
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
lightning storm.
Electronic equipment can be damaged by static electrical discharge. Before handling it,
put on an antistatic discharge wrist strap to prevent damage to electronic components.
Place equipment in antistatic packing material when transporting or storing. When
working on equipment, always place it on an approved antistatic mat that is electrically
grounded.
put on an antistatic discharge wrist strap to prevent damage to electronic components.
Place equipment in antistatic packing material when transporting or storing. When
working on equipment, always place it on an approved antistatic mat that is electrically
grounded.