Xmark Corporation ITG Manual Do Utilizador

100-13551 Commerce Parkway
Richmond, BC  Canada V6V 2L1
Toll Free (800) 667-9689
Phone (604) 207-7760 
Fax (604) 207-7765
E-mail: info@exi.com
www.exi.com

© September 2004, eXI Wireless Inc. Specifications subject to change without notice.
980-000037-000R1.00

INFANT TAG OVERVIEW

As an essential part of the HALO Infant
Protection System™, the Infant Tag helps to
protect and identify infants in your care.
Each tag is labeled with a unique serial
number and expiry date for easy, accurate
identification.

The bottom of the tag is curved to ensure a
snug and comfortable fit.

Tag pulse technology allows tags to emit
periodic signals to the HALO system that
allow facilities to accurately track and locate
infants. Infant Tags are available with and
without tag pulse technology.

APPLICATION

Proper banding will limit the incidence of
nuisance alarms. A properly fastened strap
should keep the bottom of the Infant Tag
against the infant’s skin, but it should
neither restrict the infant’s circulation nor
cause discomfort or chafing.

eXI recommends using either the Velcro
Strap or the Stockinette to attach the Infant
Tag. However, other options are available.
For more information, contact your dealer
or eXI directly.

Hold Infant Tag with top
uppermost

Remove Secure Strip from
tape by slightly bending
tape, allowing strip to separate

Center strip on bottom of tag and
press firmly into place

Follow instructions for type of strap used

Insert velcro tab end of strap through one
arm of tag. Guide it from top to bottom of
tag, with tan color next to the infant’s skin

Pull taut

Peel backing from Secure Strip

Place tag on infant’s calf or upper arm

Guide tab end
through tag’s
other arm

Fold tab back
over arm to
adhere velcro to
strap

Peel backing from Secure Strip

Place tag on infant’s calf or
upper arm

Center stockinette
over tag

Peel backing from Secure Strip

Place tag on infant’s calf or upper arm

Wrap Coban around tag,

covering the tag
completely; ensure that
you do not wrap the Coban
too tightly

CLEANING

In order to disinfect without causing
damage to the tags, use one of the
following cleaning methods:

METHOD 1

Scrub each tag with germicidal solution of
approximately 60 seconds 
Note: Phenolic or iodine base solution is
preferred

Wipe each tag individually (using a new

alcohol wipe for each)

Allow tag to dry for 30 seconds

METHOD 2

Use cold sterilization in Cidex or Totacide
Note: Do not immerse tags for more than 30
minutes

METHOD 3

Use gas diffusion sterilization methods
Note: Battery leakage may occur if tags are
exposed to heat in excess of 57°C (135°F)

The Velcro Strap and the Stockinette are
disposable and intended for single use,
which eliminates the need for sterilization
and disinfection. If need be, the Velcro Strap
will withstand hand washing.

STORAGE

Store tags in eXI’s Tag Rack at room
temperature. The
Tag Rack holds up
to 42 curved
Infant Tags.

Regularly rotate
your tag inventory
so that tags are used evenly.

ORDER INFORMATION

To re-order tags, secure strips, or bands,
contact your dealer or eXI directly. Use the
order numbers in bold and italics to ensure
you get exactly what you need.

eXI Wireless Systems

Model No.: Infant Tag

IC: 2877A-ITG

FCC ID: HE7ITG

*  This device complies with Part 15 of the FCC Rules. Operation is subject to the following two rules: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any
changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.