Murata Electronics North America 2410G Manual Do Utilizador

Set Data Rate Divisor
Sets the serial bit rate between the modem and the host.  This command takes effect
immediately and will require adjusting the host serial rate to agree.  Nonstandard rates
may be programmed by entering a data rate divisor computed with the following formula:

DIVISOR = (230400/RATE)-1

Round all non-integer values down.

Set Protocol Mode
Enables the base station to operate in a multipoint network.  Depending on the user
application, more or less acknowledgment may be desired by the application.  Remotes
can operate in transparent mode even though the base station is operating in one of the
nontransparent modes.

When using a protocol mode, make sure to count in packet overhead when calculating
network performance.  Refer to the section on Protocol Modes for details on each format.

Network commands are used to set up a WIT2410 network and to set radio addressing
and configuration.

Command

Description

wb[?|0|1]

Set Transceiver Mode

0

 = remote (default)

1

 = base station

wd[?|1-3f]

Set Default Handle

Used to override automatic handle assignment by the base station

30

 = default

wg[?|0|1]

Enable Global Network Mode

0

 = Link only to hop pattern specified by wn parameter (default)

1

 = Link to any hop pattern, regardless of wn parameter

wl[?|0-ff]

Set lockout key allowing network segregation beyond network number

0 = default

wn[?|0-3f]

Set Hopping Pattern (Network Number)

0

 = default

wp[?|0|1]

Set Transmit Power

0

 = 10mW

1

 = 100mW (default)

wr?

Read Receive Signal Strength

wu[?|0|1]

Set Point-to-Point Direct Mode

0 = Multipoint mode (default)

1 = Point-to-point direct mode

dx[?|0-ff]

(remote only)

Set Range optimization

0

 = default