Murata Electronics North America HN1010 Manual Do Utilizador
HN-1010 Outdoor Base/Remote Station
M-2410-0010, Rev -
HopNet Family of Products
7
HN-1010 Outdoor Base/Remote Station
Introduction
The HopNet Outdoor Base/Remote Station (HN-1010) features a low-cost, rugged,
compact, NEMA 4X/IP 66 enclosure for outdoor or harsh industrial environments.
You can use the HN-1010 with all HopNet products and with any existing WIT2410
network.
compact, NEMA 4X/IP 66 enclosure for outdoor or harsh industrial environments.
You can use the HN-1010 with all HopNet products and with any existing WIT2410
network.
Data Transmission
The HN-1010 supports up to 62 remotes on a single network. You can operate 16
different networks in the same area without conflicts. The HN-1010 can easily
transmit over 1.0 mile line of sight. You can extend this range by adding a HopNet
Repeater (HN-2010) or by using gain antennas.
different networks in the same area without conflicts. The HN-1010 can easily
transmit over 1.0 mile line of sight. You can extend this range by adding a HopNet
Repeater (HN-2010) or by using gain antennas.
Automatic repeat requests (ARQ) and acknowledgments inside the radio are
transparent to the user equipment. User data rates of 230 Kbps are supported with
built-in CRC/ARQ error protocols. See below for jumper settings. The HN-3500
adapter can be used to adapt RS-232 signals to RS-485 in situations where long data
cable runs are required. The HN-1010 uses a 9-pin Conxall weatherproof connector
for power, data, and control signals. See the illustration below of the 9-pin Conxall
connector.
transparent to the user equipment. User data rates of 230 Kbps are supported with
built-in CRC/ARQ error protocols. See below for jumper settings. The HN-3500
adapter can be used to adapt RS-232 signals to RS-485 in situations where long data
cable runs are required. The HN-1010 uses a 9-pin Conxall weatherproof connector
for power, data, and control signals. See the illustration below of the 9-pin Conxall
connector.
2
8
1
3
4
7
6
5
9