Murata Electronics North America SEM2410 Manual Do Utilizador

 





14 022101 

The “radio” command provides access to several sub-commands that are useful in 
configuring the WIT2410 in the SEM.  The format for the radio commands is 

, where the 

 is either of the letters ‘A’ or 

‘B’ used to specify to which radio the sub-command should be applied.  The SEM uses 
only the radio ‘A’ designation; the ‘B’ designation is for future use. The command 

 can be used to display the banner from the radio.  This is useful in 

determining the unique ID of the radio and the version of firmware running in the radio.   

Radio Commands 
The radios in the SEM devices are set with factory defaults which should be sufficient for 
most applications. For other applications, the following radio commands can be used to 
fine tune the performance of the SEM. 

help 

Displays command list 

banner 

Displays power on banner for the radio in the SEM  

defaults 

Resets the radio parameters to the factory shipped values

 

maxremotes [ 

 0..5] 

Displays value currently in use 

Sets the maximum number of subscribers the SEM  will allow to 
register.  

 Default 

= 

5 

network [ 

 0..63] 

Displays current SEM network number 

Sets the network number for the SEM 

 Default 

= 

0 

param <rcmd> 

 [arg0,arg1…] 

Sets other radio parameters. Should not be used unless instructed to by 
Cirronet Technical Support 

radio a 

show 

Displays radio parameters that have been modified from factory 
settings 

 

 
help 

Displays list of sub-commands under the radio command. 

 
banner 

Displays the power on banner of the radio inside the SEM. 

 
defaults 

Replaces any modified parameters with the factory default values.  

 
maxremotes  Sets a limit to the number of remotes SEMS that a master SEM can have 

registered simultaneously. The default is 5 but the parameter can range 
from 1 to 5. If more than maxremotes remote SEMs attempt to connect to 
the access point, they will be denied.