Murata Electronics North America XDM2140 Manual Do Utilizador
9.3.1 Error Codes
Error Codes are listed in Table 38 below.
Error Code Details
Number
Error
Description
0
DIAG_NO_ERR
No command-specific errors
1
DIAG_EXE_ERR
XDM2140 unable to execute command
2
DIAG_PARAM_ERR
Illegal parameter in the request
Table 33
9.3.2 Parameter Type 0x01 - Network ID
The network ID is the identification number used to distinguish different wireless networks. In order to
join a specific network, the XDM2140 must have the same network ID as the network Gateway. This
parameter is only valid for the Set Parameter command. Upon receiving this request, the XDM2140
stores the new network ID in its persistent storage area, but continues to use the existing network ID.
The XDM2140 must be reset in order to begin using the new network ID.
join a specific network, the XDM2140 must have the same network ID as the network Gateway. This
parameter is only valid for the Set Parameter command. Upon receiving this request, the XDM2140
stores the new network ID in its persistent storage area, but continues to use the existing network ID.
The XDM2140 must be reset in order to begin using the new network ID.
Parameter Type 0x01 Set Request Details
Message Byte
Description
Data Type
Value
1
Command type
unsigned char
0x87
2
Parameter type
unsigned char
0x01
3-4
Network ID
unsigned char
Network ID
Table 34
The following packet is sent in response to a request to set the network ID.
Parameter Type 0x01 Set Response Details
Message Byte
Description
Data Type
Value
1
Command type
unsigned char
0x88
2
Parameter type
unsigned char
0x01
3
Error code
unsigned char
Error code
4
Data length
unsigned char
0x00
Table 35
9.3.3 Parameter Type 0x02 - XDM2140 State
This parameter is only valid for the Get Parameter command and is used to retrieve the XDM2140’s
current network connection state.
current network connection state.