Murata Electronics North America Z2405HPA Manual Do Utilizador

The ZMN2405HP developer’s kit includes three code loads which can be programmed into the 
ZMN2405HP module. All the modules come programmed from the factory, but RFM provides 
the capability to change the code in the module. The ZMN2405HP has bootloader code which 
allows the module firmware to be programmed through one of the two serial connections to the 
development board. The bootloader code removes the need for a JTAG programming device. 
 
Three files are provided in the Code Loads directory of the Software and Manuals CD included 
with this kit. The files all start with “CSM” followed by “-C” for the coordinator, “-R” for the router, 
and “-E” for the end device. After the node type designation is the firmware version indicated by 
“vxxxxx” where xxxxx represents the version number.  
 
The modules are programmed using the ZProg.exe Windows utility program found the in the 
same Code Loads directory on the CD. The program can be run from the CD or copied to your 
computer. When ZProg starts, the following window will appear.  

 
Select the serial port to which the dev kit board is connected from the drop down menu and click 
on Connect. If the serial port does not show up in the list, check to make sure no other program 
is open using that port, such as ZBDemo.  
 
A Detecting Radio screen will appear and you will be prompted to cycle power to the dev kit. 
Simply unplug and the reconnect the power supply cord from the dev kit board. Once the 
module has been detected, the Detecting Radio window will close and the Connect button on 
the ZProg will change to disconnect. 
 
Click on the Select File button to choose the code load to use. If you know the complete path to 
the code load you want to use, you can type it in the Program Filename field. When you click on 
the Select File button the following screen will open.